Here are the pictures, last Wednesday and Thursday
Just ignore the head T_T i'm going to change it.
Here's the problem...but we can fix that later.
Go to the sunlight and check the excess then mark it up with your pencil.
Then slice the excess part and sand it all away to make it smooth.
And we got this!
Lots of seamlines needs to fix up
and i made the puttying last saturday to hide the seamlines between those pla-plates.
I just sand it with 600 GRIT and a FINE GRIT Sandpaper after the curing.
Then yesterday, i started to cut the parts of the shield by using .5mm pla-plate and a reference picture of it.
If you're tired to measure the size again and again, you can just cement it over the pla-plate and remove the excess.
And sand each side of it.
Made of 3 of .5mm pla-plate to make it thicker.
And here's the shield line art from Wiki, and a flat image of the shield from zerogunz wip section.
I resize the flat image of it in Ms Word then print it out and put it over the pla-plate with masking tape and start slicing each part!
The last weapon for the appearance is this shampoo! why? you can use their cups instead of buying a clear pla-plate.
See you on my next WIP. Thanks for reading.
0 comments:
Post a Comment